COLD PATCH REPAIR KIT THUMBS UP YP3210
Inner tube repair tapes and glue
Inner Tire Repair Kit
Quick and reliable repair
Each patch is enclosed in a protective airtight film to prevent dust and dirt contamination
The special rubber solution will permanently bond the patch with the inner tube in only about 5-10 minutes
The kit includes:
20 ml glue
48 rounded patches with a diameter (ø25 mm)
Size of the box: 130x20x65 mm
How to use:
1. Mark the location of the flat tire.
2. Using sandpaper, lightly sand the area around the hole. Clean an area larger than the size of the patch.
3. Clean and wait for it to dry completely.
4. Open the glue. Apply a thin layer of glue and spread evenly around the hole location.
The spread area of the adhesive should be larger than the size of the patch.
Use the back of the patch to spread the glue evenly in a thin layer.
Do not apply too much glue. The adhesive layer should not protrude more than 2 millimeters from the patch.
5. Allow the glue to dry. This may take a few minutes. Test by touching only the perimeter of the adhesive, not where the patch will bond.
6. Peel off the patch.
7. Center the patch in the hole and place the patch on the tire.
8. Apply pressure to the patch, especially the edges.
9. If possible, maintain pressure for 5-10 minutes.
Color | Black |
---|---|
Frame Size | 420mm |